Click Advanced to input further information if your ISP requires. Click Save and then click Renew.ģ ) PPPoE: By default, the router uses the IPv4 account to connect to the IPv6 server. Red blanks must be filled in.ġ ) Static IP: Fill in blanks and click Save.Ģ ) Dynamic IP (SLAAC/DHCPv6): Click Advanced to input further information if your ISP requires. If you do not know what your internet connection type is, contact your ISP or judge according to the already known information provided by your ISP.Ĥ.Fill in information as required by different connection types. Your ISP provides information about one of the following IPv6 internet connection types: PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge).ġ.Visit, and log in your TP-Link ID or with the password you set for the router.ģ.Enable IPv6 and select the internet connection type provided by your ISP. If you still cannot access the internet, refer to the FAQ section for further instructions.If you use Dynamic IP and PPPoE and you are provided with any other parameters that are not required on the page, please go to Advanced > Network > Internet to complete the configuration.If your internet connection type is BigPond Cable, please go to Advanced > Network > Internet to set your router.It may take 1-2 minutes to make the settings valid. After the connection succeeds, the screen will display as follows. Different parameters are needed according to the Secondary Connection you have chosen.Ħ.To check your internet connection, click Network Map on the left of the page. Different parameters are needed according to the Secondary Connection you have chosen.ĥ )If you choose PPTP, enter the username and password, and choose the Secondary Connection provided by your ISP. PPPoE users usually have DSL cable modems.Ĥ )If you choose L2TP, enter the username and password and choose the Secondary Connection provided by your ISP. Dynamic IP users are usually equipped with a cable TV or fiber cable.Ģ )If you choose Static IP, enter the information provided by your ISP in the corresponding fields.ģ )If you choose PPPoE, enter the username and password provided by your ISP. Parameters on the figures are just used for demonstration.ġ )If you choose Dynamic IP, you need to select whether to clone the MAC address. Since different connection types require different cables and connection information, you can also refer to the demonstrations in Step 4 to determine your connection type.Ĥ.Follow the instructions on the page to continue the configuration. If you are unsure of what your connection type is, click Auto Detect. You can also modify the settings according to the service information provided by your ISP.įollow the steps below to check or modify your internet connection settings.ġ.Visit, and log in with your TP-Link ID or the password you set for the router.ģ.Select your internet connection type from the drop-down list. In this part, you can check your current internet connection settings. Then follow the instructions to bind the router to your TP-Link ID.Ģ. Then follow the step-by-step instructions to connect your router to the internet.ģ.To enjoy a more complete service from TP-Link (remote management, TP-Link DDNS, etc.), log in with your TP-Link ID or click Register Now to get one. If you need the IPv6 internet connection, please refer to the section of Set Up an IPv6 Internet Connection.įollow the steps below to set up your router.ġ.Visit, and log in with the password you set for the router.Ģ.Click Quick Setup on the top of the page. The Quick Setup Wizard will guide you to set up your router. Monitor the Internet Traffic Statistics.Backup and Restore Configuration Settings.Chapter 12 Customize Your Network Settings.
0 Comments
Leave a Reply. |